LINOVISION MNVR7608 User Manual page 50

Configure Event Detection
Set the event detection parameters according to actual situation to lower false detection rate.
Steps
1. Go to Configuration → VCA → Driving Behaviors → Driving Behaviors.
2. Select Channel No.
3. Check Enable.
4. Check behaviors to analyze and configure their parameters.
Distraction Prompt Detection
When the device detects that the driver is not concentrating on driving, the device will alarm
to prompt the driver.
Fatigue Driving (Closing Eyes) Detection
When the device detects that the driver is too tired to close his or her eyes, the device will
alarm.
Fatigue Driving (Yawn) Detection
When the device detects that the driver is too tired to yawn, the device will alarm.
Phone Call Detection
When the device detects that the driver is using the mobile phone, the device will alarm.
Smoking Detection
When the device detects that the driver is smoking, the device will alarm.
Seatbelt Unbuckled Detection
When the device detects that the driver's seatbelt is not buckled, the device will alarm.
Driver Exception Detection
When the device detects that there are some exceptions with the driver, the device will
alarm.
IR Interrupted Sunglasses Detection
When the device detects that the driver is wearing IR interrupted sunglasses, the device will
alarm.
Alarm Triggering Time
Device will alarm when the corresponding driving behavior lasts for the set time.
Confidence
Available for phone call detection and smoking detection. The higher the value is, the lower
the false detection rate. You are recommended to use the default value.
Stop Detections in Low Speed
The feature is valid when GPS positioning succeeded. When the vehicle speed is lower than
the set value, all the event detection will stop.
Mobile Video Recorder User Manual
39