Configure G-Sensor Alarm - LINOVISION MNVR7608 User Manual

Note
● The combination mode means the positioning module will be selected automatically. For
example, if GPS/BDS is selected, GPS or BDS will be selected automatically.
● The positioning module varies with models. The actual interface prevails.
5. Optional: Check Enable of Satellite Time Sync to synchronize the device time with satellite time.
6. Configure the speed limit.
1) Select Speed Units.
2) Enter Speed Limit of Alarm.
If the vehicle speed exceeds the set value, the device will alarm.
7. Enter Blind Replacement and GPS Upload Interval.
Blind Replacement
In the area without network signal, after the signal restores, the positioning information from
the start time without network signal to the current time will be uploaded. For example, if
you enter 3, after the network signal restores, the data from 3 days ago to now will be
uploaded.
GPS Upload Interval
The positioning information will be uploaded according to the set interval.
8. Check the channel(s) you want the positioning information to be displayed.
The positioning information will be displayed in the live view and playback images of the
selected channel(s).
9. Configure the linkage actions.
– If you want the overspeed vehicle to trigger the speed alarm, check Trigger Alarm Output
and check the alarm output.
– If you want the overspeed vehicle to trigger the device to beep, check Audible Warning.
10. Click Save.
11. Optional: Click Location Status to view the positioning information.

6.4 Configure G-Sensor Alarm

G-Sensor detects and records acceleration information in 3-axial (X, Y, Z) directions.
Before You Start
Connect a G-sensor to the device.
Steps
1. Go to Configuration → Vehicle → G-Sensor.
Mobile Video Recorder User Manual
31