10.1 Configure Motion Detection Alarm
When motion detection alarm is configured, once a motion event is detected, the device starts to
record and multiple linkage actions will be triggered.
Steps
1. Go to Configuration → Event → Basic Event → Motion.
2. Select Channel No.
3. Check Enable Motion Detection.
4. Draw detection area.
1) Click Draw Area.
2) In live view area, drag to draw the detection area.
3) Click Stop Drawing.
5. Set Sensitivity.
6. Configure arming schedule. For detailed steps, refer to "Configure Arming Schedule".
7. Configure linkage method. For detailed steps, refer to "Configure Linkage Actions".
8. Click Save.
10.2 Configure Video Loss Alarm
When the recorder cannot receive video signal from the analog cameras, the video loss alarm will
be triggered. Linkage actions, including audible warning and alarm output, can be set to respond.
Steps
1. Go to Configuration → Event → Basic Event → Video Loss.
2. Select Channel No.
3. Check Enable Video Loss Detection.
4. Configure arming schedule. For detailed steps, refer to "Configure Arming Schedule".
5. Configure linkage method. For detailed steps, refer to "Configure Linkage Actions".
6. Click Save.
10.3 Configure Video Tampering Alarm
A tampering alarm is triggered when the camera is covered and the monitoring area cannot be
viewed. Linkage actions, including audible warning, alarm output, can be set to respond.
Steps
1. Go to Configuration → Event → Basic Event → Video Tampering.
Mobile Video Recorder User Manual
Chapter 10 Events and Alarms
51