Measure Mode; Total Mode - KROHNE OPTISWIRL 5080 Handbook

OPTISWIRL 5080

5.3.3 Measure mode

In normal operation, the flowmeter displays those measurements specified in the setup mode.
If configured for manual cycle, you can cycle through the measurements manually by using the
up/down arrow keys. If configured for auto cycle, the display cycles through the measurements
specified. If, while in auto cycle, you want to see a specific measurement momentarily, advance
to that measurement with the down arrow key. Use the up arrow key to go to a specific
measurement and stay there. You can then resume scanning by pressing the down arrow key.

5.3.4 Total mode

"TotPul, TotNet or TotGrd" is used to turn a totalizer on, pause the totalizer or to clear (reset) the
totalizer. This is done by pressing the enter key and selecting "On, Paused or Clear" and
pressing the enter key again. Before doing this you may be asked for a password.
If so, enter the "LoPwd or HiPwd" for "TotPul and TotNet". Enter the "HiPwd" for "TotGrd".
INFORMATION!
Clearing "TotGrd" also clears "TotPul and TotNet".
04/2020 - 4005615602 - MA OPTISWIRL 5080 R02 en www.krohne.com
OPERATION
5
47