KROHNE OPTISWIRL 5080 Handbook page 68

OPERATION
5
Communicator parameters
Parameter
Analog Output
AO/PV LRV
Basic Setup
Dev ID
Device Err Status
Device Warn Status
Diag/Service
Fld Dev Rev
Hardware Rev
LFCI Adjust Factor
Manufacturer
PO/PV LRV
Process Parameters
Process Variables
Pulse Map
PV
PV % Rnge
PV Configuration
PV Damp
PV Min Span
PV USL
Scaled D/A Trim
Serial Number
Universal Rev
Variable Map
Velocity Status
Vortex Freq
Table 5-17: Communicator parameters
68
Explanation
Path to configuring the analogue output.
Shows the AO/PV LRV.
Path to basic setup parameters.
Shows the device identification number.
Shows the device error status.
Shows the device warning status.
Path to status, test, and calibration parameters.
Shows the software version of the vortex flowmeter.
Shows the vortex flowmeter hardware revision level.
Enter the low flow cut-in user factor.
Shows the manufacturer.
Shows the PO/PV LRV.
Path to configuring the process parameters.
Path to viewing the process variable values.
Shows whether the pulse is mapped to "Volume Flow", "Mass Flow",
"BVolFlow," or "Velocity".
Shows the value of the process variable.
Shows the process variable in percent of range.
Path to configuring the PV parameters.
Shows the damping time.
Shows the minimum span.
In the "Basic Menu", shows the upper sensor limit.
In "Review", shows the upper sensor limit.
Procedure to trim the low and high mA output values of the flowmeter to
match the output of a plant standard measurement device.
In "Detailed Setup", enter the serial number.
In "Review", shows the serial number.
Shows the universal command set revision level.
Map the output as the primary, secondary, tertiary, or fourth output.
Shows the Velocity status.
Shows the vortex frequency.
www.krohne.com
OPTISWIRL 5080
04/2020 - 4005615602 - MA OPTISWIRL 5080 R02 en