KROHNE OPTISWIRL 5080 Handbook page 67

OPTISWIRL 5080
Cross reference
4 EGU
4 K EGU
4 Setting
4 LfUFac
4 Map
4 EGU
4 Preambl
4 Config
4 Show1st
4 Frequ
4 Pulse
4 Factor
4 EGU
4 Pwidth
4 TubAlp
4 Tub Dia
4 Updist
4 LoPwd
Menu level 5
5 FlwVol
5 Format
5 TotGRD
5TotNet
p/CuFt
p/l
Table 5-16: Parameters
04/2020 - 4005615602 - MA OPTISWIRL 5080 R02 en
Parameter
Grand Total Units
K Factor Units
LFCI Index
Low Flow Cut Factory
Net Total Map
Net Total Units
Num Req Preams
Piping Config
Primary Display
Pulse Max Freq
Pulse Mode
Pulse Resolution
Pulse Total EGU
Pulse Width
Tube Alpha
Tube Diameter
Upstream Distance
User Password
Show
Display Format
Totalizer Grand
Totalizer Net
p/CuFt
p/l
www.krohne.com
Explanation
In "Detailed Setup", select the grand total units from the
picklist provided.
In "Review", shows the grand total units.
In "1 Setup", path to selecting the K-Factor unit.
Shows the low flow cut-in picklist number.
Set to factory value of LFC.
Map the "Net Total" to "Volume", "Mass" or "BVolume".
In "Detailed Setup", select the net total units from the picklist
provided.
In "Review", shows the net total units.
In "1 Setup", configure the number of preambles to be sent in
a response message from the flowmeter to the host.
In "Detailed Setup", select the type of piping configuration
from the picklist provided.
In "Review" shows the type of piping configuration.
Select the first measurement to be displayed.
In "1 Setup", set the upper frequency end point corresponding
to the highest frequency as 10, 100 or 1000 Hz.
In "1 Setup", select the type of pulse output as "Rate", "Total",
"Raw" or "Off".
In "1 View", shows the type of pulse output.
Enter the units per pulse.
Select the unit from the picklist provided.
Select the pulse width as 0.5, 5 or 50 ms.
Enter the thermal coefficient of expansion (alpha) in m/m/°K.
Enter the custom flowtube diameters in meters.
In "1 Setup", enter the distance to the first upstream
disturbance in pipe diameters.
User Password
Map the PV to "Volume Flow".
Set the display format (to decide how many decimal points to
be used for displaying a particular value).
Grand Totalizer
Net Totalizer
Sets the K-Factor unit to pulses per cubic foot.
Sets the K-Factor unit to pulses per liter.
OPERATION
5
67