KROHNE OPTISWIRL 5080 Handbook page 66

OPERATION
5
Cross reference
3 FlwDen
3 Flw Tmp
3 Visc
3 Add Drop
3 Pulse
3 Pulse (2 MeaStat)
3 mA Out
3 FlwDmp
3 FlwMap
3 FlwEGU
3 FlwURV
3 RdCorr
3 SelfTst
3 Set mA
3 Set DIG
3 New
3 Set Hz
3 Special
3 TmpRGU
3 Custom
3 VelEGU
Menu level 4
4 HiPwd
4 lf EGU (Customer Label)
4 Offset
4 Slope
4 Cycle
4 Show
4 Map
66
Parameter
Process Density
Process Temperature
Process Viscosity
Pulse Add Drop
Pulse Operations
Pulse Output
Pulse Out
Pulse Status
PV AO
PV Damping
PV Map
PV Units
PV URV
Reynolds Correction
Reynolds Number
Self Test
Set Analog Out
Set Digital Out
Set Fluid Defaults
Set Pulse Out
Special
Temperature Units
Tube Diameter
Velocity Unit
Admin Password
Custom Dens Label
Custom Dens Offset
Custom PV Slope
Display Cycle
Display Setup
Grand Total Map
www.krohne.com
Explanation
In "1 Setup", enter the flow density in the density unit
specified.
In "Detailed Setup", enter the flow temperature in the
temperature unit specified. In "Review", shows the process
temperature.
In "1 Setup", enter the base viscosity in the viscosity unit
specified.
In "1 Setup", configure the pulse compensation (signal
conditioning) feature "On" or "Off".
Procedure to start, pause or clear the pulse total.
Path to configuring the pulse output.
Shows the pulse value.
Shows the pulse status.
Shows the analogue output of the process variable.
Enter the damping time if different than the one shown.
Map the PV to "Volume Flow", "Mass Flow", "BVolFlow" or
Velocity.
In "1 Setup", select the PV units from the picklist.
In "Detailed Setup", select the PV units from the picklist.
In the "1 Setup", shows the process variable upper range
value which can be configured.
Shows the Reynolds correction status (on/off).
Configure the Reynolds number correction feature "On" or
"Off".
Procedure to self test the device.
Procedure to set the analogue output to 4 mA, 20 mA or
another value.
Procedure to set the digital output to override the PV, net
total, grand total, or vortex frequency.
Path to setting the default parameters for the type of fluid
selected (liquid, gas, or steam).
Procedure to set the pulse output to 0 Hz, the maximum
frequency, or another value.
Path to configuring special flowtube parameters.
In "Detailed Setup", select the temperature unit from the
picklist provided.
In "Review", shows the temperature units.
Enter the custom flowtube diameters in meters.
In "1 Setup", select the unit from the picklist.
Set Admin password.
Enter the label for your custom density unit.
Enter any offset.
Enter a conversion factor for the custom PV unit.
Specify whether the list of measurements configured to be
displayed are scanned automatically or manually.
Set the parameters to be shown on the display.
Map the "Grand Total" to "Volume", "Mass" or "BVolume".
04/2020 - 4005615602 - MA OPTISWIRL 5080 R02 en
OPTISWIRL 5080