Sharp MX-4100N Operation Manual page 546

Specifying the original scan size (by paper size)
If the original is a non-standard size or you wish to change the scan size, touch the [Original] key to specify the original
size manually. Place the original in the document feeder tray or on the document glass and follow the steps below.
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
The automatically detected original size appears to the right of the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
Auto
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
Auto
Manual Manual
5½x8½ 8½x11R
5½x8½R 8½x13(216x330)
3
8½x11 8½x14
Size Input
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 39-3/8" (1000 mm) (the maximum height is 11-5/8" (297 mm)).
☞
TRANSMITTABLE ORIGINAL SIZES
• To specify an AB size for the scan size, touch the [AB
Scan/Original
Scan Size
5½x8½
4
2-Sided 2-Sided
Booklet Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
(page 5-53)
OK
100% Send Size
Auto
8½x11
Image Orientation
(1) (2)
OK
11x17
AB
Inch
Long Size
OK
Send Size
100%
Auto
Image Orientation
Touch the [Scan Size] key.
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
(page 5-17)
Inch] key to highlight the [AB] side and then specify the scan size.
Touch the [OK] key.
5-56
SCANNER/INTERNET FAX
Contents