Sending An Image In Usb Memory Mode - Sharp MX-4100N Operation Manual

SENDING AN IMAGE IN USB MEMORY MODE

Follow the steps below to send a scanned image to a commercially available USB memory device that has been
connected to the machine. This stores the file in the USB device.
• Use a FAT32 USB memory with a capacity of no more than 32 GB.
• When a default address is configured in "Default Address Setting" in the system settings (administrator), the mode cannot
be changed. To switch to USB memory mode, touch the [Cancel] key in the touch panel and then follow the steps below.
1
• When placing the originals, orient them as shown below.
Originals
Portrait orientation*
2
1
Landscape orientation
1
* To place a large portrait-oriented original, place it as shown above in "Landscape orientation" and specify the
placement orientation in step 4.
• Place 5-1/2" x 8-1/2" (A5) size originals in portrait (vertical) orientation (
( ), an incorrect size will be detected. For a 5-1/2" x 8-1/2"R (A5R) size original, enter the original size manually.
• Originals cannot be scanned in succession from both the automatic document feeder and the document glass and
sent in a single transmission.
Connect the USB memory to the USB
connector (Type A) on the machine.
Place the original.
Original size
detector
Do not place any objects under the original size detector.
Closing the automatic document feeder with an object
underneath may damage the original size detector plate and
prevent correct detection of the document size.
Document feeder tray
Place the original face up.
1
1
5-35
SCANNER/INTERNET FAX
Document glass
Place the original face down and align the
corner with the tip of the arrow mark
top left corner of the document glass scale.
1
1
). If placed in landscape (horizontal) orientation
Contents
in the