Xerox Phaser 7760 Service Manual page 390

024-942 Booklet Sheets Counts Over
Booklet Sheets Counts over.
Procedure
Procedure not available.
Status Indicator RAP's
024-942, 024-943
024-943 Booklet Low Staple
Booklet Low Stapler Low Staple signal detected just before Stapling operation.
Booklet Stapler Low Staple signal was detected at power On, at initialization, or when the Inter-
lock was closed.
Procedure
Supply the staples. The problem is resolved.
Y N
Enter Service Diagnostics
Printer Status Page > hold the Up and Down buttons simultaneously > Run Service
Diagnostics > OK. Actuate the Booklet Stapler Low Staple (Front/Rear). 'LOW'
ples available) is displayed.
Y N
Check continuity between the Staple and Booklet PWB, and between the Booklet
PWB and Finisher PWB
Y N
Repair the open circuit or short circuit.
Replace the Booklet Stapler Low Staple Front/Rear
tinues, replace the Finisher PWB
Replace the Finisher PWB
(PL 21.12).
If the problem continues, replace the Finisher PWB
the Booklet PWB (PL 21.12).
January 2010
2-354
Menu: Printer Menu > Troubleshooting > Service Tools >
(Figure 1). The continuity check is OK.
(PL 21.16). If the problem con-
(PL 21.12).
(PL 21.12). If the problem continues, replace the Booklet PWB
(PL 21.12). If the problem persists, replace
Phaser 7760 Color Laser Printer
(sta-
Revised