Adj 12.7 Booklet Staple Alignment - Xerox Phaser 7760 Service Manual

ADJ 12.7 Booklet Staple Alignment

Parts List on PL 21.16, PL 21.20
Purpose
To center the Staple Position on the fold in the SE direction.
Check
1. Ensure the trays used are correctly programmed.
2. Ensure the Fold Skew is within specification
3. Ensure the Fold Position is within specification
4. Ensure the Staple Position is within specification
5. Set up the machine according to instructions in
tomer mode.
Table 1 Booklet Jobs
Select Paper
Supply Select Booklet Creation Mode
11 x 17 / A3 SEF Booklet Layout, 2 sided originals / Booklet Fold and Staple 2 sheets
6. Measure X1 and verify against specification in
Figure 1 Staple Specification
7. If X1 is out of specification, go to the Adjustment procedure.
Repairs and Adjustments
ADJ 12.7
(ADJ 12.4).
(ADJ 12.5).
(ADJ 12.6).
Table 1 and run the Booklet job in Cus-
Booklet Size
Figure 1.
Adjustment
1. Enter Service Diagnostics
Printer Status Page >hold the Up and Down buttons simultaneously > Run Service
Diagnostics > OK.
2. Select Adjustments/Calibrations and press OK.
3. Select Finisher Fold Position and press OK.
4. Select ADJ 12.7 and press OK.
5. Perform adjustment using Adjustment locations in
NOTE: To increase X1, the current NVRAM value should be decreased. To decrease X1,
the current NVRAM value should be increased.
Table 2 Adjustment Location
Job # NVRAM Default
1 2300 30
6. Check the output against specifications in
Alignment meets specification or customer request.
January 2010
4-116
Menu: Printer Menu > Troubleshooting > Service Tools >
Table 2.
Range Remark
0 ~ 50 1 count = 0.26 mm.
Figure 1. Repeat steps 5 - 6 until the Staple
Phaser 7760 Color Laser Printer
Revised