Xerox Phaser 7760 Service Manual page 25

Mounting Surface Specifications
These specifications apply to any Phaser 7760 printer used as a table-top printer, without a
lower tray assembly or cart. There are 4 feet on the bottom of the printer. The right hand side of
the printer is more susceptible to problems due to foot placement.
1. In order to function properly, the printer must be located on a surface with the following
minimum dimensions (Figure 3). All 4 feet must rest squarely on the mounting surface.
Figure 3 Mounting Surface Dimensions
2. Mounting surface flatness must be within the range shown in
Figure 4 Mounting Surface Flatness
Revised
Phaser 7760 Color Laser Printer
3. The printer must not be tipped or tilted more than 5 mm as in
Figure 4.
Failure to adhere to these mounting specifications will void all guarantees of print-quality
and/or performance. Known problems that can occur as a result of exceeding the mount-
ing surface specifications are:
•
•
January 2010
xxi
Figure 5 Maximum Dimension for Tilting or Tipting
Color-to-Color mis-registration, primarily in the horizontal (laser scan) direction.
A smear or line of toner approximately 40 mm from the trailing edge of the print.
Figure 5.
Introduction
Specifications