Xerox Phaser 7760 Service Manual page 405

024-977 Stapler Feed Ready Fail
• At the staple preparation operation at initialization, the Staple Ready Sensor does not go
to ready (L) status after 13 ready attempts.
• The Stapler Ready Sensor is turned off (H) just before the Staple.
Procedure
Procedure not available.
Revised
Phaser 7760 Color Laser Printer
024-978 Booklet Stapler NG
Error signal On and Ready signal On output from the Staple were detected after Booklet Sta-
pling operation.
Procedure
Check continuity between the Booklet PWB and Finisher PWB
check is OK.
Y N
Repair the open circuit or short circuit.
Replace the Staple (PL 21.16). The problem is resolved.
Y N
Replace the Booklet PWB
(PL 21.12).
If the problem continues, replace the Finisher PWB
January 2010
2-369
(Figure 1). The
(PL 21.12). If the problem continues, replace the Finisher PWB
(PL 21.12).
Status Indicator RAP's
024-977, 024-978
continuity