Xerox Phaser 7760 Service Manual page 102

A B C
Check that the voltage at P/J542 pins 1, 2, 5, and 6 each drop to approximately +22
VDC. The voltage at P/J542 pins 1, 2, 5, and 6 all drop to approximately +22
VDC when [008-036] is entered.
Y N
Replace the Tray Module PWB
Replace the Takeaway Motor 1
Check the Takeaway Motor 1 (PL 16.15
for damage, contamination and misalignment.
The Tray 3 Feed/Lift Motor energizes.
Y N
Check the circuit of the Tray 3 Feed/Lift Motor
troubleshooting procedure.
• Check the Tray 3 Feed / Lift Motor and its associated gears
alignment.
• Ensure that the Tray 3 Chute (PL 16.6) is properly seated and not damaged.
• Ensure that the connectors shown in the circuit diagrams
are securely connected and that the wires are not damaged.
• If these checks are OK, replace the Tray Module PWB
Figure 1 007-110 Takeaway Sensor
Status Indicator RAP's
007-110
(PL 16.15 - TTM or PL 15.9 - 3TM).
(PL 16.15 - TTM or PL 15.9 - 3TM).
- TTM or PL 15.9 - 3TM) and its associated gears
(Figure 2). Refer to the OF 99-9
(PL 2.4) for damage and mis-
(Figure 1, Figure 2,
(PL 16.15 - TTM or PL 15.9
RAP for
Figure 3)
- 3TM).
Figure 2 007-110 Tray 3 Feed/Lift Motor
January 2010
2-66
Revised
Phaser 7760 Color Laser Printer