Xerox Phaser 7760 Service Manual page 341

012-900 Paper at Buffer Path Sensor
Control logic reports paper at the Buffer Path Sensor.
Initial Actions
Check the following:
• Paper on the Buffer Path Sensor
• Obstructions in the paper path
Procedure
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer
Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics >
OK. Actuate the Buffer Path Sensor (PL
Revised
Phaser 7760 Color Laser Printer
21.10). The display changes.
Figure 1 012-900 Buffer Path Sensor
Y N
Check the circuit of the Buffer Path Sensor
Sensor Procedure for troubleshooting procedure.
Check the following:
• Ensure that the connectors shown in the circuit diagrams are securely connected and that
the wires are not damaged
• Finisher for a docking failure
If the above checks are OK, then replace the Buffer Path Sensor
sists, replace the Finisher PWB
January 2010
2-305
(Figure 1). Refer to Section 6,
(PL 21.10). If the problem per-
(PL 21.12).
Status Indicator RAP's
Transmissive
012-900