Xerox Phaser 7760 Service Manual page 501

3. Removing the ATC Sensor (Figure
a. Lift the Lock and move end away from the Tab.
b. Remove the Seal from the under the Sensor.
Figure 2 Removing ATC Sensor
Revised
Phaser 7760 Color Laser Printer
2). Replacement
NOTE: Ensure to install the Seal
Remove the ATC Sensor Setup Data Tag from new sensor. On tag, highlight K, C, M, or Y as
required for color of developer housing. Raise the IBT Cam Lever and install Tag in position
shown (Figure 3).
Figure 3 Installing ATC Sensor Setup Data Tag
NOTE: Perform ATC Sensor Setup,
Printer Menu > Troubleshooting > Service Tools > Printer Status Page >hold the Up and
Down buttons simultaneously > Run Service Diagnostics > OK.
January 2010
4-59
(Figure 2) correctly and fully seated to prevent from leakage.
(ADJ 9.2 - Section 4) using the Service Diagnostics
Repairs and Adjustments
Menu:
REP 9.26