Set-Up Mode; Introduction; Entering Set-Up Mode - Pace ST 85 Operation & Maintenance Manual

Introduction

The menu driven LED Display of the ST 85 system in the Set-Up Mode allows you to
easily customize your system. No calibration adjustments are necessary to maintain
the accuracy of the system.
In Set-Up Mode, you can:
1. Enter, remove or change a Password.
2. Set the Default Temperature scale to °F or °C as desired.
3. Change the Upper and Lower Temperature limits.
4. Enter a Temperature Offset Constant (Auto Tip Temperature
Compensation).
5. Enable or disable the Temperature Setback feature and adjust the time-
out period (if enabled).
6. Enable or disable the Auto Off feature and adjust the time-out period (if
enabled).
7. Enable or disable the Average Temperature feature.
The following instructions should be performed to familiarize the operator with the
system.

Entering Set-Up Mode

1. Place Power Switch in the "OFF" ("0") position.
2. Press and hold the Program Key (
3. Place Power Switch in the "ON" ("1") position. Release the Program Key
(
30
).

Set-Up Mode

)