General Information; Introduction; Specifications - Pace ST 85 Operation & Maintenance Manual

General Information

Introduction

Thank you for purchasing the PACE model ST 85 Digital Desoldering/Soldering System.
This manual will provide you with the information necessary to properly set up, operate
and maintain the ST 85 system.
The ST 85 systems are available in either the 115 VAC, or 230 VAC version which
incorporates a highly responsive SensaTemp (closed loop) control system providing up
to 80 Watts of total power to a single output channel. The 230 VAC version system
bears the CE Conformity Marking which assures the user that it conforms to all the
requirements of council directive EMC 89/336/EEC. The systems package the power
source with a selection of accessories and functional aids.
The 115 VAC version system conforms to all the requirements of FCC Emission Control
Standard, Title 47, Subpart B, Class A. This system has been tested and found to
comply with the limits for a Class A digital device, pursuant to part 15 of FCC rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause interference in which
case the user will be required to correct the interference at his own expense.

Specifications

System Power Source Power Requirements
ST 85 - Operates on 97-127 VAC, 50/60Hz, 90 Watts maximum
at 115 VAC, 60Hz
ST 85E - Operates on 197-253 VAC 50/60Hz, 80 Watts maximum
at 230 VAC, 50Hz
Shop Air Input Requirements:
Pressure -
Air Flow -
Temperature Specifications
Handpieces
Tip Temperature Range: 204 to 482°C (400 to 900°F) nominal.
Temperature Stability: ±1.1°C (±2°F) at idle from set tip temp.
NOTE - Actual minimum and maximum Operating Tip Temperatures may vary depending
on Handpiece, Tip Selection and application.
4
5.48 Bar (80 p.s.i.) recommended
6.17 Bar (90 p.s.i.) maximum
45.3 SLPM (1.6 SCFM) minimum