Installing The Batteries; Using The Remote Control; Connection; Connecting To Cable Tv - Strong SRT 3002 User Manual

Digital hd cable receiver
Table of Contents

Advertisement

20. OPT
21. TEXT
22. SUB
23. 
24. 2
25. 5/6
26. 4
27. u
28. 78
29. 3
30. COLOUR BUTTONS
* Subtitles, Videotext, EPG (Electronic Programme Guide), and Audio languages are depending on availability in the specific broadcast
**This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.

2.5 Installing the batteries

Open the cover on the remote control and insert 2x AAA batteries into the compartment. Correct position of the polar
diagram shows the batteries inside the compartment.
1. Open the cover.
2. Insert the batteries.
3. Close the lid.
WARNING
The batteries should not be recharged, disassembled, electrically short-circuited, be mixed or
used with other types of batteries.

2.6 Using the remote control

To use the remote control, point it towards the front of your receiver. The remote control supports a range of up to 5
meters distance to the receiver at an angle of up to approx. 30 degrees.
NOTE
Managing the receiver will be limited or not possible if there are obstacles between the
remote control sensor (at the front panel of the receiver) and the remote control. Direct
sunlight or very bright light can reduce or disturb the reception of the remote control signals.

3.0 CONNECTION

3.1 Connecting to cable TV

Connect your receiver to the wall connector provided by your cable operator, using a high quality coaxial cable (75
Ohms). Normally, wall connections could be either F-type or IEC male type. Use a cable with suitable connectors. This
receiver has an IEC female input.

3.2 Connecting to TV with HDMI cable

The TV set shall be connected with the receiver using a good quality HDMI cable. This connection gives the highest
possible quality.
6
No function.
Opens the Teletext if available*
Opens a list of subtitles if available*
No function
Hold play during playback/starting Timeshift mode**
Fast rewind/fast forward.
Starts recording of the currently watched programme**
In multimedia menu for starting the playback
Jumps to the previous/next file during playback
Stop playback.
In different menus for specific functions
Fig. 4
Fig. 5
Fig. 6
Fig. 6

Advertisement

Table of Contents
loading

Table of Contents