Table of Contents
Advertisement
Clean the Reflector Insert
WARNING:
you clean the reflector.
AVERTISSEMENT :
refroidir avant de nettoyer le réflecteur.
1. To protect the lamp housing during cleaning, remove the LED lamp
housing by loosening the attachment screw and pulling the housing
straight out. (See image on
2. Remove the barrel rotation knob located at the bottom of the barrel.
Use a Phillips screwdriver to remove the retaining bolt located on top
of the reflector housing.
3. Rotate the barrel 45° in either direction. Carefully remove the barrel
from the reflector housing.
4. Clean the reflector insert. Remove any dust with a blast of oil-free air
or wipe with a clean, lint-free cloth. You can use isopropyl alcohol,
distilled water, or a 50%-50% mixture of each to clean the surface.
5. Insert the barrel into the reflector housing with the iris/pattern slot on
top. Align the triangles on both parts.
6. While gently pressing in, rotate the barrel 45° clockwise until it sets
into position, and then rotate the barrel counterclockwise 45°. The
barrel should be firmly attached and the triangles should be aligned.
7. Reinstall the barrel rotation knob and tighten the retaining bolt.
8. Reinstall the LED lamp housing and tighten the attachment screw. See
Install the Source 4WRD Color II Retrofit on page 8
22
Unplug the fixture and allow it to cool before
Débrancher le projecteur et le laisser
page 9
Source 4WRD Color II Installation and User Manual
.)
.
Advertisement
Table of Contents
