ETC S4WRDCII Installation And User Manual page 10

Remove Incandescent Lamp Housing
1. Unplug the Source Four incandescent fixture and place it on a flat,
stable surface.
2. Loosen the brass thumb screw located above the beam adjustment
knob. The lamp housing is now loose.
3. Remove the lamp housing from the fixture body.
Note:
ETC to recycle the burner assembly, contact ETC Technical Services
for more information. See
page 2.
Install the Reflector Insert
When you use the Source 4WRD Color II with a Source Four fixture body,
you must install the reflector insert provided with the Source 4WRD Color II
in the Source Four fixture body.
CAUTION:
4WRD Color II retrofit. Using the reflector insert with an
incandescent Source Four lamp can result in damage to the
product.
1. Remove the shutter barrel from the fixture in order to access the
reflector housing.
Loosen the barrel rotation knob at the bottom of the reflector housing
and loosen the retaining bolt on the opposite side of the reflector
housing. Rotate the shutter barrel and remove it from the reflector
housing.
6
The burner assembly is no longer needed. If you would like
Use the reflector insert only with the Source
Source 4WRD Color II Installation and User Manual
Help from ETC Technical Services on