Maintenance; Clean The Fixture - ETC SolaPix 19 XT User Manual

Maintenance

CAUTION:
ATTENTION :
l'entretien.
CAUTION:
maintenance, use ingress protection (IP) test equipment to confirm that the
fixture is tightly sealed after you reassemble the fixture. ETC recommends
that you use the High End Systems SealerAtor IP Tester or equivalent
equipment.
To ensure that the fixture remains in good working condition and does not fail prematurely,
ETC recommends that you perform regular maintenance on the fixture.
Keep the following in mind during regular service and inspection:
All screws for installing the fixture or parts of the fixture must be tightly connected and
•
must not be corroded.
There must not be any deformations to the housing, protective glass, lenses, rigging, and
•
installation points (ceiling, suspension, trussing).
Moving parts must not show any signs of wear and must move smoothly without issue.
•
The power supply cables must not show any damage, material fatigue, or sediment.
•
If spare parts are required, order only genuine parts from ETC or your authorized ETC
•
dealer.

Clean the Fixture

1. Clean the protective glass and lenses only when necessary, and only use a Silky Microfiber
Optical Cloth with purified water or an ammonia-free glass cleaner such as Miller
Stevenson MS-260 Glass Cleaner.
2. Clean the fans regularly to ensure maximum airflow and efficient cooling. This will ensure
that the light source operates in the best possible condition.
Note:
cleaning them. Letting the fans spin while using compressed air could damage the
fans.
3. Over time, some outgassing may occur inside of the protective glass. If this occurs, open
the head of the fixture and clean the lenses and the inside surface of the protective glass.
Maintenance
RISK OF ELECTRIC SHOCK! Disconnect power before servicing.
RISQUE DE CHOC ÉLECTRIQUE! Couper l'alimentation avant
If you disassemble the SolaPix 19 XT fixture while performing
If you use compressed air to clean the fans, hold the fan blades in place while
29