Connect Cables - ETC S4WRDCII Installation And User Manual

Connect Cables

WARNING:
fixture below 5°C (41°F). When the fixture has been stored or
transported in cold temperatures, allow it to warm to room
temperature for a minimum of 1 hour before applying power.
Applying power to a cold fixture will cause damage to the
fixture and void ETC warranty.
1. Connect one RJ45 data cable for data-in and one for data-thru, as
needed. Use the strain relief at the bottom of the fixture to support
the data cables (see image in
Leave a loop of data cable between the connector and the strain relief
to ensure that the connection point is not stressed.
• To order an RJ45-to-socket XLR adapter, use ETC part number
W6538.
• To order an RJ45-to-plug XLR adapter, use ETC part number
W6539.
2. If this is the last fixture in the line, terminate the fixture with a
120 Ohm resistor. Please contact your ETC customer service
representative to purchase ETC part number N4086. See
ETC Technical Services on page 2
3. Connect the fixture to a non-dimmable power source.
DMX Dimming
• When using DMX over Cat5, use Cat5e or better.
• Cable distance for full DMX daisy chain must not exceed 300 m
(1000 ft).
• Up to 32 fixtures can be connected together into a daisy chain.
• The fixture cannot be controlled via Ethernet protocols and should
not be directly connected to an Ethernet system.
Source 4WRD Color II Installation and User Manual
Do not use or store the Source 4WRD Color II
Install the Fixture on the previous page
.
).
Help from
11