Clean The Fan Filter - ETC Releve Spot User's Operation Manual

Clean the Fan Filter

To ensure proper air flow and cooling in the LED module, remove any buildup of dust on the fan
filter and fan blades on a routine basis according to the installation environment.
WARNING:
power to the luminaire before working inside could result in serious injury
or death.
Disconnect power from the luminaire and follow appropriate
Lockout/Tagout procedures as mandated by NFPA 70E. Any work must
comply with OSHA Safe Working Practices and follow requirements by local
code.
AVERTISSEMENT :
l'intérieur du luminaire sans avoir déconnecté le courant peut entrainer des
blessures graves, voire mortelles.
Déconnectez l'alimentation du luminaire et suivez les procédures de
Consignation/Déconsignation appropriées prescrites par la norme NFPA 70E.
Tout travail doit être conforme aux consignes de sécurité du travail de
l'OSHA et respecter les codes locaux.
Tools and supplies required:
#2 Phillips screwdriver
•
compressed air
•
vacuum
•
1. Disconnect power to the luminaire.
2. Use a Phillips screwdriver to loosen the captive screw securing the fan cover in place, and
then rotate the fan cover down to expose the fan and fan filter.
3. Using compressed air, blow the dust from the filter and the fan assembly. Alternatively,
use a vacuum to remove accessible dust and buildup from the filter and the fan assembly.
4. Reattach the fan cover and secure it in place using the captive screw.
46
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
RISQUE DE MORT PAR ÉLECTROCUTION! Travailler à
Relevé Spot User Operations Manual