Installation; Mounting The Tilt Protection Holders (Chambers With Window) - Binder 9010-0323 Operating Manual

4.

Installation

4.1

Mounting the tilt protection holders (chambers with window)

For chambers equipped with the option „door with window" it is recommended to install the supplied tilt
protection.
Scope of delivery of tilt protection kit (Art.no.
• 2
screws
• 2 tilt protection
holders
Preparing the tilt protection holders
• Depending on the desired wall distance, you can bend the tilt protection holders

Figure 8: Variable length of the tilt protection
Installation on the chamber
•
Plug the two tilt protection
el. The screw holes in the rear wall and in the
• Fix the tilt protection
holders
Wall mounting
• Then fix both tilt protection
BD / BF / ED / FD / FED (E3.1) 03/2019
8009-0870):
holders each with the tab on the provided spot on the edge of the rear pan-
tilt protection
each with one of the supplied screws on the chamber rear wall.
holders on the wall, each with 2 screws Ø 6mm suitable for the wall (B)
accordingly.



holder depending on the bend
holders must align.
page 17/106