Network Configuration For Chambers With Ethernet Interface - Binder 9010-0323 Operating Manual

11.

Network configuration for chambers with Ethernet interface

The settings of this submenu are used for networking chambers with an Ethernet interface, e.g. to con-
nect them with BINDER's APT-COM™ 4 Multi Management Software (option, chap. 12.1).
This menu subsequently offers the following settings:
• Display of the chamber's MAC address (no setting)
• Switching on and off the DHCP state
• Entering the IP address
• Entering the subnet mask number
• Entering the gateway number
5x
without fan
6x
with fan
5 x
Displaying the chamber's MAC address serves to identify the chamber in the Ethernet network.
Example: 00-0F-67-0F-42-40
00-0F
BD / BF / ED / FD / FED (E3.1) 03/2019
From Normal display
with the arrow-up button to the user menu
Confirm with OK.
Enter the password (factory setting: 00 00)
and confirm each entry with OK.
with the arrow-up button to the Ethernet menu.
Confirm with OK.
The first digits of the MAC address are shown.
Continue with OK. The middle digits of the MAC address are shown.
Continue with OK. The last digits of the MAC address are shown.
67-0F 42-40
page 54/106