Ruijie RG-AP810-I Hardware Installation And Reference Manual page 39

Hardware Installation and Reference Guide
distance between them must be greater than 30 mm.
All cable trays and their accessories shall be smooth and free from sharp edges.
○
Holes in metal, through which cables pass shall have smooth, well-rounded surfaces
○
or be protected with insulating bushings.
Use proper cable ties to bind cables together. Do not tie two or more cable ties to
○
bind cables.
Cut off excess cable tie cleanly with no sharp edges after bundling cables, as shown
○
in Figure B-2.
Figure 7-5 Cutting off Excess Cable Tie
If cables are to be bent, bind them first but do not tie cable ties within the bend to
○
avoid stress on the cables, which may otherwise cause the wires inside to break, as
shown in
Figure 7-6 Do Not Tie Cable Ties within the Bend
Wrap up unnecessary or excess cables and bind them to the appropriate rack
○
position, where device operation is not affected and no damages occur to the device
.
Figure 7-6
31
Appendix