Table of Contents
Advertisement
Hardware Installation and Reference Guide
6.2.2
Ethernet port is not working after the Ethernet cable is plugged
in
Verify that the device at the other end of the Ethernet cable is working properly. And then
verify that the Ethernet cable is capable of providing the required data rate and is
properly connected.
6.2.3
Wireless client cannot find the AP
(1) Verify that the device is properly powered.
(2) Verify that the Ethernet port is correctly connected.
(3) Verify that the AP is correctly configured.
(4) Move the client device to adjust the distance between the client and the AP.
6.2.4
LED keeps blinking red
The LED stays blinking red for a long time, indicating the Ethernet port is not connected. Verify
the Ethernet connection.
6.2.5
LED keeps blinking green
The AP performs initialization after power on. During this period, the LED keeps blinking
green and does not turn solid until the initialization is completed. Note: If the blinking persists
for an hour, it indicates the device initialization fails and the device is faulty.
6.2.6
LED keeps blinking orange (Fit AP mode)
Sometimes the AP performs firmware upgrade after power on. During this period, the LED
keeps blinking orange and does not turn solid until the upgrade is completed. Note: Do not
plug or unplug the power cord when the Status LED is blinking as firmware update takes time.
If the blinking persists for ten minutes, it indicates the device fails to complete firmware
upgrade and is faulty.
6.2.7
LED does not turn solid blue or blinking blue
After the system starts and the LED does not turn solid blue or blinking blue, probably
because the AP has not established a proper CAPWAP connection with the AC. Verify the AC
is operational and configured properly.
7
Appendix
7.1
Connectors and Media
1000BASE-T/100BASE-TX/10BASE-T
28
Appendix
Advertisement
Table of Contents
Need help?
Do you have a question about the RG-AP810-I and is the answer not in the manual?
Questions and answers