Cut The Media (Manual) - Canon Colorado 1630 Operation Manual

Cut the media (manual)

Introduction
When you manually cut media, the printer does not use the embedded knife but you have to use
your own knife or pair of scissors.
How the media is cut depends on the media type configuration in the RIP. For more information,
Change the media settings on page
see
Before you begin
Use a knife or pair of scissors that is sharp enough to cut the media.
Procedure
1. On the operator panel tap on the [Cut] icon on the top right.
The printer transports the media automatically. The operator panel displays a request to make a
manual cut.
2. Move the media guides to the sides.
3. When a tension bar is present, a window telling you to remove the tension bar opens. Remove
the tension bar from the media path.
4. Use a knife to cut the media. Cut the media as close as possible to the take-up roll.
IMPORTANT
Cut as indicated in the illustration. Check that nothing is blocking the cutting path.
67.
Cut the media (manual)
Chapter 4 - Handle the media 147