Change The Https Security Settings - Canon Colorado 1630 Operation Manual

Change the HTTPS security settings

Introduction
You can change the default HTTPS security settings to best fit your configuration.
Illustration
Procedure
1. Open the settings editor.
2. Click on [Configuration] →[Security].
3. Click on [Edit] in the [HTTP/HTTPS] header.
4. The [Use of less strong cipher suites] setting is by default disabled to secure data communication,
which is suitable for recent browsers. If you want to use older browsers or HTTPS clients, you can
change the setting to [Enabled].
5. The [Minimal version of TLS protocol] setting is by default set to [TLSv1.2]. [TLSv1.2] is a
stronger protocol and [TLSv1.0] is weaker. You can change the setting to the minimum security
protocol that fits your security requirements. It is also possible to use a lower protocol to allow
communication with older browsers or HTTPS clients.
6. Click on [OK] to save the settings.
Chapter 8 - Configure the network and security settings
Change the HTTPS security settings
289