Print And Wind Without A Tension Bar - Canon Colorado 1630 Operation Manual

Print and wind without a tension bar

Introduction
Winding media without a tension bar, loose winding, is used for most media that can be
transported well and is not too weak.
Before you begin
• The use of the tension bar is set in the media type configuration in the RIP software. For
winding without a tension bar you must select [no tension bar] under [Winding tension]. For
more information, see
• Make sure you have loaded a take-up roll on the roll winder. For more information, see
take-up roll core onto the roll winder on page
• The printer is ready to print.
CAUTION
• Do not position the tension bar when there is no media present. Keep your fingers away
because the tension bar can fall down.
• The winder has an emergency stopping device; It is located on the winder. Activating this
emergency stopping device stops all winder motion.
Procedure
1. On the operator panel tap on the [Output] icon.
2. Tap on [Output configuration].
3. Make sure [Wind the output] is set to [Yes].
Change the media settings on page
Print and wind without a tension bar
67.
115.
Chapter 4 - Handle the media
Load a
119