Set The Energy Save Modes - Canon Colorado 1630 Operation Manual

Set the energy save modes

Introduction
You can enable the energy save modes, automatic wake-up mode and automatic shutdown
mode, via the settings editor. Set timers for each day of the week to wake up or turn off (standby
mode) the printer.
NOTE
• When the printer is turned off the printer is in standby mode: power to the system is never
cut.
• Before the printer can be turned off automatically (standby mode), the printer first has to enter
low power mode. The printer will enter low power mode automatically after 30 minutes of
inactivity. So when the printer was still active before the shutdown time, the printer will first
take 30 minutes to enter low power mode before it will automatically shut down (standby
mode).
Procedure
1. Open the settings editor.
2. Click on [Preferences] →[System settings].
3. Go to the [Energy save modes] header and click on [Edit]. Log in as a System administrator.
A window opens.
4. Select [Enabled] for [Automatic wake-up] and [Automatic shutdown].
5. Click on [Ok].
6. Go to the [Wake-up timers] header and click on [Edit].
A window with timers for each day of the week opens.
7. Fill out if you want the printer to wake-up and shutdown for each day of the week. If yes, also fill
in the times for wake-up and shutdown.
8. Click on [Ok].
Set the energy save modes
Chapter 9 - Troubleshooting and support 303