Print And Wind With A Tension Bar - Canon Colorado 1630 Operation Manual

Print and wind with a tension bar

Print and wind with a tension bar
Introduction
Winding media with a tension bar, tight winding, is only used for weaker media in order to
prevent media transportation issues. Media that is weak and sensitive for buckling, but not too
stiff, can be wound with a tension bar in unlocked position.
Before you begin
• The use of the tension bar is set in the media type configuration in the RIP software. For
winding with a tension bar, you must select [tension bar] under [Winding tension]. For more
information, see
• Make sure you have placed a take-up roll core on the roll winder. For more information, see
Load a take-up roll core onto the roll winder on page
• Make sure you have tape ready.
• The printer is ready to print.
CAUTION
• Do not position the tension bar when there is no media present. Keep your fingers away
because the tension bar can fall down.
• The winder has an emergency stopping device; It is located on the winder. Activating this
emergency stopping device stops all winder motion.
Procedure
1. On the operator panel tap on the [Output] icon.
2. Tap on [Output configuration].
3. Make sure [Wind the output] is set to [Yes] .
NOTE
Make sure you set the output configuration in time, as you cannot change the
configuration once the media has passed the clamp.
122 Chapter 4 - Handle the media
Change the media settings on page 67.
115.