Canon Colorado 1630 Operation Manual page 103

14. On the operator panel, select the correct media type and fill in the media width.
15. When the media you use has an upward curl select [ Upward curled media].
This setting persists as long as the media is assigned. When enabled, the system feeds the media
to the output position. You can then open the top cover and guide the media. After you close the
top cover, the media is transported to the clamp. Open the top cover and guide the media again.
Printing starts after these actions have been completed.
16. Select if and what type of clean cut you want the printer to make, when you use the media for the
first time.
For winding with a tension bar or with a locked tension bar the clean cut is neglected.
17. Tap on [Save].
NOTE
For the highest output quality, it is advised to always perform a media calibration when
you load a new media type or a new media width. For more information, see
the media on page
113.
Load a media roll for inside printing
Calibrate
Chapter 4 - Handle the media 103