Refill The Chiller (First Design) - Canon Colorado 1630 Operation Manual

Refill the chiller (first design)

Introduction
You can refill the chiller without service assistance.
NOTE
There are 2 types of chillers. In the first design, the condenser surface is located on the left side
of the chiller. In the new design, the condenser surface is located directly behind the cover. This
procedure describes the first design.
First design
When to do
• The operator panel gives an orange warning when you can refill the chiller.
• The operator panel gives a red warning when you must refill the chiller.
Before you begin
Use Colorado 1630 prescribed:
New design
Chapter 6 - Maintain the system
Refill the chiller (first design)
237