Load A Media Roll (Position 2) - Canon Colorado 1630 Operation Manual

Load a media roll (position 2)

Load a media roll (position 2)
Introduction
An optional second media roll can be loaded to your printer for optimal productivity.
NOTE
You can use optional grip lock to insert the feed media shaft into the core of the new media roll.
You can load a media roll without the optional grip lock. This procedure describes both
situations.
Before you begin
Before you load a roll on the printer:
• Make sure you have added a media profile with the correct media type via the RIP. For more
information, see
• Check the media size of your roll before loading. When your media size is not present in the list
on the operator panel, you can type it in.
• Put on gloves to avoid pollution of the paper by your fingerprints.
CAUTION
• Watch your fingers when you handle the media roll.
• Loading heavy media, 25 kg (55 lb) or more, has to be done by two people or with the help of
external lifting tools.
IMPORTANT
• Do not use dented or damaged media rolls to prevent damage to the printheads.
• Only open the media drawer when the indicator light on the drawer is on. Do not open the
drawer when the light is off, you can damage the machine.
Procedure
1. Pull firmly to open the media drawer.
2. Place the new media roll, with the media flap on the bottom and towards you, on the roll loading
station.
90 Chapter 4 - Handle the media
Configure media in the RIP on page
42.