Canon Colorado 1630 Operation Manual page 143

7. On the operator panel tap on the [Media] icon.
Select the required media and media width.
8. On the operator panel tap on the [Default settings][System] icon and change the leading and
trailing edge length to 1600mm (63 inch).
9. Prepare a nest of prints for the outside of the media in one of the supported RIP software
applications.
In ONYX the nesting function is called [Group jobs]. Change the group setting from [Conserve
media] to [Group jobs together]. The RIP will not change the order of the images and will treat all
jobs in the group as 1 image.
The nest includes:
• a lead-in image (in any color)
• the user images
• a lead-out image (in any color)
NOTE
Please note that when you apply additional space between the separate images, you
have to subtract this additional space from the 1600 mm (63 inch) at the trailing edge.
10. Submit the job to the printer and follow the instructions on the operator panel to print the first
side.
11. Tape the media to the empty take-up media roll core.
12. Place the tension bar.
13. Lock the tension bar.
14. Adjust the position of the media guides on the left and right side.
15. On the operator panel tap the [Completed] when you are ready to start the print job.
16. Cut the media manually beneath the printed line when the print is completed and follow the
instructions on the operator panel.
17. Remove the take-up media roll from the winder, see
winder on page 151
18. Cut the media precisely on the printed line. Do this outside of the printer.
19. Place a new empty take-up roll core and push the media shaft back on the winder.
This ends the printing procedure of side 1.
20. Prepare the nest of prints for side 2 of the double-sided print in one of the supported RIP software
applications.
The nest includes:
• a lead-in image (in any color)
• the user images
NOTE
Depending on the application you may need to rotate or mirror the images for side 2.
21. Load the media roll for inside printing on position 2 in the media drawer, with the flap pointing
towards you.
22. Load the media in the inside printing manner.
23. On the operator panel change the trailing strip to 250 mm (9.84 inch) in the [Default settings].
24. Submit the job to the printer and follow the instructions on the operator panel to print the second
side.
in the operation guide.
Print double-sided with manual cut
Unload a take-up media roll from the roll
Chapter 4 - Handle the media 143