Turn the printer on after a power cut
Turn the printer on after a power cut
Introduction
When power has been cut to the machine, you have to power the machine on. The machine has
to be on to keep the printer in optimal condition.
NOTE
There are 2 types of the cover under the roll winder. In the new design you can access the power
switch through an opening in the cover.
First design
Procedure
1. Move to the media output side.
2. Pull to open the cover under the roll winder.
NOTE
For the new design, skip this step. You can access the power switch without opening
the cover.
3. Switch the power switch to the 'off' position.
4. Wait 1 minute.
5. Switch the power switch to the 'on' position.
332
Chapter 9 - Troubleshooting and support
New design