Change The System Administrator Password - Canon Colorado 1630 Operation Manual

Change the System administrator password

Change the System administrator password
Introduction
For security reasons it is advised to change the System administrator password during
installation or immediately after. Next to that, you should change the password periodically.
Before you begin
Log in as System administrator in the settings editor.
Change the password
1. Open the settings editor.
2. Click on [Configuration] →[Users].
3. Check the box in front of [System administrator] and click on the [Edit] icon above.
4. In the window, fill in [Password] and [Confirm password] with your new password.
5. Click [ Ok] to save the password.
Reset the System administrator account
It is also possible to reset the System administrator account and go back to the default values.
Click on [Configuration] →[Security] →[Restore factory-defined account values] and click on [Ok].
A password prompt will pop up. It is possible to send a recover email. The mail server must be
configured to be able to do this.
276 Chapter 8 - Configure the network and security settings