Table of Contents
Advertisement
2
Operation and Features
& SOUR:MEM:OUTP ON, (@1)
& SOUR:MEM:CURR:MEAS, (@1)
& SOUR:MEM:LIST:STOR, (@1)
& SOUR:TRIG:STRG
& SOUR:MEM:ARM (@1)
& INIT:TRAN, (@1)
Execute commands from memory list using the remote trigger command
Commands from the memory list can be executed by sending the remote
trigger command. There will be some small time delay between the
channels if two or three channels are triggered by the remote command at
the same time. The channel execution sequence will start in the order of
channel 1, channel 2, and channel 3.
56
This command stores the "set output on"
command into the active memory list of
channel 1.
This command stores the "measure current"
command into the active memory list of
channel 1.
This command stores all commands from the
active memory list of channel 1 into the
nonvolatile memory. This command can be
omitted if this operation is not required.
This command configures the backplane trigger
to star trigger.
This command sets the arm type of channel 1 to
the memory list arm.
This command arms channel 1.
U2722A/U2723A User's Guide
Advertisement
Table of Contents
