Orp Measurement Settings; Settings For Orp Measurements; Sensor-Independent Settings; System - Xylem SI Analytics HandyLab 600 Operating Manual

Settings
Menu item
System / General / Lan-
guage
System / General / Audio
signal
System / General / Illumi-
nation
44
You can change the interval (1 ... 999 days):
1. Open the menu for measurement settings with <ENTER>.
2. In the Calibration / Calibration interval menu, set the calibration interval
with < >< >.
3. Confirm the setting with <ENTER>.
4. Quit the menu with <M>.
7.2

ORP measurement settings

7.2.1 Settings for ORP measurements

The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the <ENTER> key. After completing the set-
tings, switch to the measured value display with <M>.
Default settings are printed in bold.
Menu item Possible setting
mV resolution 0.1
1
Reset -
7.3

Sensor-independent settings

7.3.1 System

To open the Storage & config menu, press the <ENTER_ > key in the measured
value display. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
Possible setting
Deutsch
English
(more)
on
off
Auto
on
off
Explanation
Resolution of the mV display
Resets all sensor settings to the
delivery condition (see section
7.4.1 R
SETTINGS
Explanation
Selects the menu language
Switches on/off the beep on keystroke
Switches the display illumination on/off
HandyLab 600
ESETTING THE MEASUREMENT
, page 47).
ba77064e04 08/2021