Table of Contents
Advertisement
Cooling Requirements
To provide adequate cooling, and air gap of approximately 75 mm (3 ins) should
be maintained around the vented sections of the instrument.
Cleaning
Use a soft, clean, damp cloth to clean the front- panel and side covers.
Use
This instrument is designed for indoor use only.
– Appliance coupler (mains input power cord) is the power disconnect
WARNING
– For continue protection against fire hazard, replace the line fuse only with
– No operator serviceable parts inside. Refer servicing to qualified
– If this instrument is not used as specified, the protection provided by the
10
device. Do not position the instrument such that access to the coupler is
impaired.
the same type and line rating (250 V, T2.5 H, 20 mm slow blow fuse with
high breaking capacity). The use of other fuses or materials is prohibited.
personnel. To prevent electrical shock do not remove covers
equipment could be impaired. This instrument must be used in a normal
condition only (in which all means for protection are intact).
Keysight N1913/1914A Installation Guide
Advertisement
Table of Contents
