Accessory And Probe Installation - Keysight PD1550A System Installation Manual

PD1550A Double-Pulse Test Rack and Safety Enclosure
Installation Guide
3

Accessory and Probe Installation

This chapter describes the PD1550A system installation process. It includes both
system rack hardware assembly as well as installation requirements for general
system operation.
Tools Required to Install Accessories
Install Tower Light on Top of the Rack
Apply Power and Turn On the PD1500A
Connect Three Short BNC Cables
Rack Connections page 49
Open the Side Shelf
Install Probe Holders
Install Components on PD1550A Interface Module
Install Coaxial Shunt Resistor
Attach 62 mm DUT Module
Connect Interface Module to PD1550A Test System
Install Gate Drive Modules on the Interface Module
Install Gate Drive Resistor Modules on the Interface
Module page 60
Connect Probes to Oscilloscope
Connect Oscilloscope Probes to DUT Interface Module
70
Connect Probe for High-Side DUT Measurements
Install UDI Cables page 75
Install Additional Test Fixture Accessories
External Loads page 76
NTC Thermistor Connector
Fan Out 24 VDC page 78
Type K Thermocouples, CH1 and CH2
Install Optional InTEST Temperature Controller with Heating
Plate page 81
Install Optional InTEST - Temptronic Thermostream
Heater/Cooler System
Thermostream Compressed Air Requirements
page 44
page 45
page 47
page 48
page 51
page 53
page 56
page 57
page 67
page 76
page 77
page 78
page 85
page 56
page 65
page 63
page
page 72
page 87
43