Install Optional Intest Temperature Controller With Heating Plate - Keysight PD1550A System Installation Manual

Install Optional InTEST Temperature Controller with Heating Plate

Install Optional InTEST Temperature Controller with Heating Plate

IMPORTANT: InTEST (Sigma Solutions) Thermal Solutions
Keysight and must be purchased directly from InTEST Thermal Solutions.
Two pieces of equipment are required: the (Watlow) Heater Control Unit and a
heating plate. Select from the list below and order directly from InTEST. The
Controller and Heating plate are for heating the Device Under Test (DUT) only, it
does not provide cooling. When running a series or loop of tests, remember that
it takes a long time for the heating plate to cool down
InTEST (Sigma Systems) Part
Number
1.001.520-Controller EZ Zone
1.001.561-HP61
1.001.486-HP168
1.001.562-HP448
XHP61PMKEY01
XHP168PMKEY01
XHP448PMKEY01
1 Size of heating plate alone, not the entire enclosure.
Figure 38 InTEST (Watlow) Controller Unit in Rack Panel and Heating Plate
1 See https://www.intestthermal.com/home. Select Product Brands, then Sigma Systems, then Platforms / Plates.
Keysight PD1550A Installation Guide
Description
Heater Control unit only, no heater plate
Small Plate only (no controller),
Medium Plate only
(no controller)
Large Plate only, (no controller)
Includes Heater Control unit and small plate
Includes Heater Control unit and medium plate
Includes Heater Control unit and large plate
Accessory and Probe Installation
1
are not available from
6.9 cm x 8.9 cm 1
, 18.2cm x 9.2 cm
1
28 cm x 16 cm
81
1