Alpha ESS SMILE5 Installation, Operation & Maintenance Manual page 9

Energy storage system

Hide thumbs Also See for SMILE5:

Table of Contents

Figure 14 Battery power cable installation diagram

Step 4

Close the battery front cover and connect the power cable at the top, which are

included in the parts list of SMILE5-BAT

Figure 15 Assemble Battery Mounting Panel

Step 5 Assemble the battery mounting panel on the battery.

INTRODUCTION

Step 6

depth of about 70mm in the wall for subsequent ﬁxation of the mounting plates.

M5*10 Screws

Step 7

gaskets.

Debris Baﬄe, drill φ8, depth about 70 mm

Figure 16 Battery Installation - Drill Holes

Position the battery parallel to the wall and use a Φ8mm drill to drill holes at a

NOTE: Place a cover (paper, foil, etc.) over the battery while drilling into the

wall to protect it from dust. In addition, at the place of installation, the slope

of the ground on a horizontal plane may not exceed 3°

φ8*60

Figure 17 Battery Installation – Mounting on the Wall

Remove the debris baﬄe and secure the battery to the wall with screws and

M6 Gasket

Table of Contents