Alpha ESS SMILE5 Installation, Operation & Maintenance Manual page 27

49
> > > Date&Time < <
> 2018 - 02 - 02
09 : 46
Step 18: Click System in the setting
menu. Click Date &Time and set up the
date and time.
NOTE:
It is needed to set the following 3 parameters for manual mode:
IP Address: IP address;
Subnet Mask: Subnet mask;
Default Gateway: Default gateway;
Automatic display one parameter:
MAC Address: display MAC Address.
> > > Language < < <
> English
Deutsch
Step 20: Click Language to set language
4.2.4.2 Additional Function Setting
A.
If you use Backup box, please set as below:
> > Backupbox
> Enable
No
Step 1: Click Enable to set yes.
CONFIGURATION NETWORK (WIFI OPTIONAL)
> > > Ethernet < < <
IP method
> DHCP
Step 19: Click Ethernet to set the IP
address. DHCP mode means that setup IP
address is set up automatically.
If you want to set up the IP address
manually, please choose manual mode
> > Information <
> SN:
AL20020YYMMXXXX
Step 21: Make sure all the following
number is correct.
> > Backupbox
> L1 1 SOC 10
L2 2 SOC 10
3 SOC 10
L3
Step 2: Set the priority of the load, L1＞
L2＞L3
CONFIGURATION NETWORK (WIFI OPTIONAL)
B.
If external device will dispatch the system, please set as following steps:
> > > > Function
> Paralel
ModBus
Step 1: Please go to the function menu,
choose "ModBus" and press enter.
C. If you use cascading function please set as following steps:
> > > > Function
> Paralel
ModBus
Step 1: Please go to the function menu,
choose "Parallel" and press enter.
> > Parallel
> Phase
L1
Step 3: Please choose "Phase" as L1
(master) and press enter.
Step 5: please repeat Step 1 to 4 to set the other device as L2 (slave) L3 (slave).
50
> > > > ModBus
> Enable OFF
Mode Slave
Step 2: Please set Modbus enable as
yes.
> > Parallel
> Phase
YES
Step 2: Please choose "Select" as "Yes"
and press enter.
> > Parallel
> Mode
Parallel Mode
Step 4: Please choose "Mode" as
"Parallel mode" and press enter.