Alpha ESS SMILE5 Installation, Operation & Maintenance Manual page 21

37
T E
000006.45
kWh
SET
Step 1: The initial interface of the meter
(normal working mode) is shown above.
000 1
Prog
SET
Step 3: Click the "Enter" button to enter
the above interface, and press the up and
down arrow keys to enter the password
0001.
Prog
SET
Step 5: Click the "Enter" button again to
enter the address interface
Prog
SET
Step 7: Click the "Enter" button and the
address setting is completed.
Prog
SET
Step 9: Click the "SET" button again to
enter the save interface
INTRODUCTION
Prog
SET
Step 2: Click the "SET" button to enter
the password interface
Prog
SET
Step 4: Click the "Enter" button and the
password input is completed.
00 1
Addr Prog
SET
Step 6: Click the "Enter" button and press
the up and down arrow keys to set the
meter address. The Grid meter (DC, AC
and Hybrid system) address is set to 001,
the PV meter (AC and Hybrid system)
address is set to 002.
Prog
SET
Step 8: Click the "SET" button to enter
the following interface
INTRODUCTION
Prog
SET
Step 10: Click the "Enter" button to enter the following interface, press the up and down
arrow keys, and set "no" to "YES" to save the configuration.
Step 11: Click the "Enter" button and the setting ends.
2.3.5.3 ACR10R
Ua 233.2 V
Ub 223.2 V
Uc 233.2 V
F 49.97 Hz
FN Set
Step 1: Activate the meter display by
pressing any key. Then click the "Set"
button.
Prog
SET
There are 5 buttons on the meter's front:
1. Enter key
2. Arrow to the right
3. Up arrow
4. SET button
5. FN key (no function)
METER SOE
HARM SETUP
ENERG
I/O
FN Set
Step 2: Use the arrow keys to select the
"SETUP" menu item and confirm your
selection with the Enter key.
38