Strong SRT 7010 User Manual page 21

If your dish is physically obstructed to the East or West (example by a wall), you can limit its moving
range by pressing the RED button to Set Limit to prevent it hitting the obstruction.
Use:
Move Continue:
Move Step(1):
7.3.1.3 Channel Scan
Automatic Scan
Satellite Scan:
Scan Mode:
Default:
Blind Scan:
NetWork:
Scan type:
Service Type:
After configuring, press OK or BLUE again to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown on
screen. During the channel search you can skip transponders by pressing the MENU button, or quit
the scan process with . When the process has been completed, all found channels will be stored
and the receiver will switch to the first found channel.
Multi-Satellites Scan:
7.3.1.4 Scanning by transponder (Manual Scan)
Press 4 for displaying the transponder list of the highlighted satellite. By pressing Press 4 again you
can switch back to the satellites list.
Single Transponder Scan:
Press tu for moving West/East. Press the opposite tu to stop moving.
Press tu for moving West/East in 0.3° step. Check if you are still well clear of
the obstruction. Then select Set East or West Limit, according to the direction,
and press OK twice to store. Repeat if there is also an obstruction to the
opposite direction. When accidentally selecting satellites from the list which
are out of range by your dish, it will not run in to the obstruction. Both limits
can be disabled with Disable Limit.
Select a satellite in the left window to be scanned. More than one can be
selected. Press BLUE for Scan. A window with scan settings will be displayed.
Use tu to select Default, Blind Scan or NetWork.
All stored transponders in the memory will be scanned.
Slow scan in 2 MHz steps. The receiver will first scan the whole frequency
band to find the transponders it can lock on. After gathering all transponders,
it scans the transponders one by one to get all available programmes.
Network search will be performed – when network information is broadcast,
new transponders will be found and stored.
Press tu to select All Channels (scrambled and free) or FTA Channels (free to
air);
Press tu to select ALL, DTV or Radio.
When using a multi feed antenna with more than 1 LNB, select the satellites
your antenna is adjusted to with the OK button. The selected satellites will be
marked by the z symbol. Set the appropriate LNB inputs in the DiSEqC point
and press BLUE for Scan. A window with scanning settings will be displayed.
After configuring the settings like explained in Single Satellite Scan above,
press OK or BLUE again to start Multi-Scan on all selected satellites.
Use the p/q buttons to highlight the transponder you want to scan and
press OK. Press BLUE for Scan. A window with scanning settings will be
displayed. After configuring the settings (explained in 7.3.1.3 above), press
OK or BLUE again to start the scanning of the highlighted transponder. When
17