Basic Adjustments; Access To The Mode: "Standard Settings - Hermle Z 327 K User Manual

Table of Contents

PRODUCT DESCRIPTION

1.8 Basic Adjustments

At commissioning of the centrifuge, you have the options to make the following basic changes:

Temperature Indication in °C or °F

Acoustic Signal Turn on / off

Volume Pre-Selection of Sound Signal

Song Selection of Sound Signal "end of run"

Keyboard Sound Turn on / off

Setting of the standby turn-off time

The following operating data can be retrieved in this menu:

Number of starts

Operating hours of centrifuge

Operating hours of motor

Software version centrifuge

Software version frequency converter

Error list

Function of the imbalance sensor

Operation of keyboard

Hardware version

Serial number of the control board

Number of rotor starts of the mounted rotor

Number of operating hours of the mounted rotor

Update touch control panel (only for service engineers)

Open the centrifuge lid and shut off the main switch. Now switch on again the main switch. For

approximately 3 seconds the software version and the model type will be shown in the display (see

Figure 4). Press during this time the keys "time" (6) and "lid" (7) simultaneously. As a result, a

display test is administered for approx. 3 seconds. All possible indications will appear at the same

time (see Figure 5). The LED light is flashing alternately with green and red color.

Figure 5

Attention:

The normal program mode can be changed back again by switching off the centrifuge, for a

short period!

All changed settings must be confirmed by the key "store" (12) or "start" (9). A confirmation

screen will appear with the word, "store", in the display "rpm/rcf" (A-1), - Only then the pre-

selections are valid (see Figure 6).

Z327K_V1.22_eng

Table of Contents