Basic Adjustments; Access To Mode: "Operating Data - Hermle Z 446 K User Manual

Table of Contents

PRODUCT DESCRIPTION

1.8 Basic Adjustments

At commissioning of the centrifuge, you have the options to make the following basic changes:

Temperature Indication in °C or °F

Acoustic Signal Turn On / Off

Keyboard Sound Turn On / Off

Volume Pre-Selection of Sound Signal

Song Selection "end of run"

If the centrifuge is still turned off, press the keys, "time" (6) and "lid" (7) simultaneously, turning on

the main switch of the centrifuge. Now release both keys. As a result, a display test is administered

for approx. 5 seconds. All possible indications will appear at the same time (see Figure 2).

Figure 2

ATTENTION:

Please notice that you must enter the program as described, under point 1.8.1

change the adjustments of the points 1.8.2 - 1.8.6. After the settings have been

stored by user, the normal program mode can be changed back again by

switching off the centrifuge, for a short period.

All changed settings must be confirmed by the key, "start" (9). A confirmation

screen will appear with the word; "store" in the display box, "rpm/rcf"(A-1) - Only

then, the pre-selections are valid, (see Figure 3)!

Figure 3

Z446K_V1.22_eng

Table of Contents